Heretic Studios 2-Inch Amber LED Pod Light; Flood Beam (Universal; Some Adaptation May Be Required)Find parts that fit my vehicle

Excellent build quality

Tape the lights to avoid scratches. They fill the opening. Place the lights at the rear most position on the brackets. Put them toward the front and they will contact the bumper opening. Use a 3/8 drive rachet with a short extension to remove the bolt at the inside position. This is the only bolt removed. The bracket orientation is for the rear edge curve to go up. This avoids installing the lights on the top of the bracket. Tighten the lights to where they will still move. (This allows final alignment). Use the 7/16 flat wrench for the final tightening. The spacer has the hollow side up so it slips over the factory-threaded screw. The outside screw holds the "other side" of the bracket. Run the harness in front of the battery and down in the opening. Then place it between the bumper and lower grill valence. This prevents it from getting in the way of the rod and latch for the hood. The factory switches make for an easy hook-up. Yellow wire for the clear and green and brown for the yellow light. It is best to use solder. The video shows just wiring them and using black tape.

Bright

Lights are very bright. Doesn't come as a set. Didn't realize until after received. Not a bad install. Should have had another set of brackets for side screws.

Heretic ditch lights

They fit well look good and work well I spent extra time running them through a relay otherwise it could have been done in an hour

Wouldn't plug into the light bar on bumper

Had to cut plug off bought harness and light and splice together

Great light bar

Bright, simple to install, nice lighting distance. No complaints so far. Installed on CBI covert series bumper