Yukon Gear Drive Axle Shaft; Front Left Inner; Dana 30 (12-15 Jeep Wrangler JK)Find parts that fit my vehicle

Quality Performance. Whether you need a strong axle for off-road use or regular street application, the Jeep Wrangler Drive Axle Shaft won’t disappoint you. It’s made for the front, left inner side of your vehicle. This axle has 27 axles, and it uses the 1350 series of 7166 U-joints. It only works for vehicles that use reverse rotation gear.

Tough Chromoly Steel. The Jeep Wrangler Drive Axle Shaft is made from tough, long-lasting Chromoly steel, which is heat-resistant. It will make this drive axle shaft last much longer than your old stock front axle. It’s 20 Inches long and weighs 7.94 Pounds. This drive axle shaft is produced according to OEM quality standards to provide you with quality and performance.

Direct-Fit Replacement. To install the Jeep Wrangler Drive Axle Shaft, you’ll need to remove your old axle shaft and replace it with the Yukon Gear one. Since it’s a direct-fit replacement, no modifications are necessary.

Limited Lifetime Warranty. If you buy the Jeep Wrangler Drive Axle Shaft, you’ll receive a limited lifetime warranty from Yukon Gear. This warranty protects you against manufacturer defects, and you can use it for as long as you own the vehicle.

Vehicle Fitment. The Jeep Wrangler Drive Axle Shaft fits 2012-2015 Jeep Wrangler JK models equipped with the Dana 30 differential system. Note that you can only install this axle shaft if the inner and outer axles are placed together.

Installation Difficulty. The installation process for the Jeep Wrangler Drive Axle Shaft takes approximately 4 hours and advanced mechanical skills.

Fitment:

• 2012 Jeep Wrangler
• 2013 Jeep Wrangler
• 2014 Jeep Wrangler
• 2015 Jeep Wrangler

CA Residents: WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov