How to Install Teraflex 4 in. Lift Kit w/o Shocks on your Wrangler

1. This install can be performed with the vehicle sit-ting on the ground. Park the vehicle on a level surface and set the parking brake. 

2. Remove from the axle bracket with either a T50 torx or a 17mm.

With the steering wheel centered, bounce the Jeep up and down. Use the bumper for this. Without moving any other components, raise the end of the track bar up into it’s mounting bracket. 

If you have room in the bracket so the hole does not overlap, go ahead and drill a hole with a 13/32” drill bit. If you drilled in the correct location the bar should line up with the new hole. 

Insert the new 10mm x 75mm bolt. Torque to 40 ft-lbs.