How to Install Smittybilt SRC Front Grille Guard Bumper on your 1987-2006 Wrangler

NOTE: Carefully read entire instructions thoroughly before attempting to assemble and/or install this product. Smittybilt is in no way responsible for any damage to the vehicle or personal injury that may occur during the installation or use of this product. CAUTION: This product is designed primarily to enhance the appearance of the vehicle. Do NOT rely on it in any way to protect against injury or death in the event of an accident. “ALWAYS WEAR YOUR SEAT BELT “

Parts Included

Front Bumper

Section One

1. Remove factory bumper (If applicable) by removing the two top and two bottom bolts. Note: Save hardware for later use.

2. Carefully place front bumper on factory frame. Align the holes in the bumpers mounting plate with the holes in the frame. Mount using the factory hardware you removed in Step 1

NOTE: To protect your investment, wax this product after installing. Regular waxing is recommended. Do not use any type of polish/wax that contains abrasives that could damage the finish.

Smittybilt (The Company) warrants to the original purchaser of this product that should the product or any part thereof, under normal use and conditions, be proven defective in material or workmanship within the warranty period of 3 years from the date of purchase, such defect(s) will be repaired or replaced (At the Company’s option) without charge for parts or labor. This warranty does not apply to any product or part thereof which, in the opinion of the Company, has suffered or been damaged through altercation, improper installation, mishandling, misuse, neglect accident or acts of nature. THE EXTENT OF THE COMPANY’S LIABILITY UNDER THIS WARRANTY IS LIMITED TO THE REPAIR OR REPLACEMENT PROVIDED ABOVE AND, IN NO EVENT, SHALL THE COMPANY’S LIABILITY EXCEED THE PURCHASE PRICE PAID BY THE PURCHASER FOR THIS PRODUCT.