How to Install a Smittybilt G.E.A.R. Rear Seat Cover on your 1987-2006 Jeep Wrangler

NOTE: Carefully read the following installation instructions for ease of installation.

STEP 1: Position the bottom portion of the cover across the seat bottom. (Fig A) Fold the seat forward and pull the side pieces of the cover back underneath the seat and secure with strap. Now pull the straps from the front back under seat and secure to rear buckles.(Fig B)

STEP 2: Position the top cover over the seat. (On 03-06 Wranglers simply lineup the latch flap with latch in seat.) (Fig C) Attach by putting Velcro straps through buckles and then pulling back and fastening. (See step 4 on how to attach Velcro straps on smaller seats) Pull bottom straps through middle of seat and secure to rear buckles. (Fig D)

STEP 3: After the cover is completely on you may adjust the straps in order to get a better fit. You can adjust the cover and straps accordingly to access any special seat features like levers or knobs.

STEP 4: On smaller seats slide the Velcro strap through the buckle and then back again through buckle. (Fig F) Attach strap to itself using the smaller pieces of sewn in Velcro (Fig G) Finally fold entire strap together and attach to beginning of strap (Fig H)

STEP 5: You may now install your pouches. What makes this cover even more versatile is that you may install the pouches wherever you like. After determining the proper place slide the pouch straps through the webbing on the seat cover ( Fig I,J), secure the pouch by fastening the snaps together. Installation is now complete. You may now make final fitment adjustments to your cover.Make sure all straps are secured and not obstructing seat functions