Talk to a Wrangler Sales Tech
1-877-870-8556
M-F 8:30A-11P, Sat-Sun 8:30A-9P
Logo Image
Black Friday is Here! Shop Early Deals >
Get $80 Off Redeem Now >

How to Install Rugged Ridge Eclipse Sun Shade (07-18 Jeep Wrangler JK) on your Jeep Wrangler

Installation Time

20 minutes

Tools Required
  • Scissors
Extreme Terrain
Shop Parts in this Guide

Factory / Before Picture

Installation Instructions:


1. Remove both freedom panels if your Jeep has a hard top or lower soft top. Flip down sun visors to access footman loops.


2. Slide front velcro straps through front footman loops and attach. The excess can be trimmed if desired. There are two straps for the center footman loop - one can be cut away if desired.


3. Flip shade forward and attach bungees with hooks to the footman loops with the hook ends pointing down.



4. Flip the shade back and attach the side bungee cords (3 per side) to the roll bar, working your way from front to back with the strap button side going under the roll bar. Note the straps should only go around the roll bar and not the plastic door surrounds.


5. Loop rear straps around the speaker crossbar and attach (1 per side). Again, the side with the strap button should go under the bar.



6. Double check bungees and velcro to make sure that everything is secure and adjust as necessary. Flip up sun visors.



Installed Photo

Installation Instructions Written by ExtremeTerrain Customer Brian Dunn 01/04/2019