FREE 1 to 3-Day Delivery on Orders $119+ Details

Talk to a Wrangler Sales Tech
1-877-870-8556
M-F 8:30A-11P, Sat-Sun 8:30A-9P
Logo Image
Black Friday is Here! Shop Early Deals >
Get $80 Off Redeem Now >

How to Install a Rugged Ridge Double Striker for XHD Bumpers on your 87-18 Jeep Wrangler YJ, TJ, JK & JL

Installation Time

2 hours

View PDF Guide
Extreme Terrain
Shop Parts in this Guide

Contents:
• Double X Striker (1)

WARNING: To avoid serious injury: never exceed 6.5 ton working load on D-Ring mounts. Use only to assist in vehicle self-recovery; never use D-Ring mounts as towing point. Inspect before use. Replace if damaged or distorted. Striker Bar is not to be used for towing or vehicle recovery.


1. If Double X Striker is being added to an existing installation; remove D-Rings and/or any top or front mounted accesoires from center section. Center section should be sitting on frame rails but not attached.

2. Place Double X Striker over center section and secure with 8 top bolts and washers (provided with center section). Do not tighten bolts.


4. Install front 8 bolts and washers (provided with center section). Do not tighten bolts.

5. Once all 16 bolts have been started, tighten the front 8 bolts, followed by the top 8 bolts. Installation is now complete.


Community Support

Word On The Trail

I found this website when I searched for Jeep Wrangler seat covers... And I ended up finding SO much cool gear for my Jeep! The site was easy to navigate, and has really cool stuff. I am excited to be a new Jeep owner.

kernerjen
Previous Slide Next Slide