FREE 1 to 3-Day Delivery on Orders $119+ Details
How to Install Rugged Ridge 2 Speaker Gray Sound Bar on your 1987-2006 Wrangler
Tools Required
- 3/16" drill bit
- (1) wire harness assemble
- Drill
- Phillips head screw driver
- T30 Torx head screw driver
Installation Instructions
(step 1)
Secure the suitable mounting bracket for your year vehicle with 1/4" - 20 x 5/8" screw and a lock washer as shown below. (Fig.1)
(step 2)
Place the sound bar on the vehicle as shown for the correct year. (Fig.2)
87-95: With guide of the holes in the mounting bracket, punch holes through the roll bar and drill 3/16" pilot holes in the roll bar. On some models there is at least one existing hole in the roll bar for mounting. Check before drilling.Apply the T30 torx head screw and flat washer to secure the sound bar.
97-06: Find the existing mounting holes in the roll bar and punch holes through padding. Fasten the sound bar with the T30 torx head screws and lock washer.
Connecting the wire harness
(step 1)
Put the wire harness down the roll bar under the padding and route along the floor under the vehicle carpet. Connect coupling at sound bar with supplied connector.
(step 2)
Find the factory radio harness under the dash board and identify the left and right speaker wires.
(step 3)
Supplied Wire Harness.
