FREE 1 to 3-Day Delivery on Orders $119+ Details
How to Install Rugged Ridge Black Door Entry Guards on your Wrangler
Shop Parts in this Guide
- Rugged Ridge Door Entry Guards; Black (76-95 Jeep CJ7 & Wrangler YJ)
- Rugged Ridge Door Handle Covers with Recess Guards; Chrome (07-18 Jeep Wrangler JK 2-Door)
- Rugged Ridge Door Handle Covers with Recess Guards; Chrome (07-18 Jeep Wrangler JK 4-Door)
- Rugged Ridge Door Handle Covers; Chrome (07-18 Jeep Wrangler JK 2-Door)
- Rugged Ridge Door Handle Covers; Chrome (07-18 Jeep Wrangler JK 4-Door)
- Rugged Ridge Door Handle Recess Guards; Chrome (07-18 Jeep Wrangler JK 2-Door)
- Rugged Ridge Door Handle Recess Guards; Chrome (07-18 Jeep Wrangler JK 4-Door)
- Rugged Ridge Door Handle Recess Guards; Black (07-18 Jeep Wrangler JK 4-Door)
- Rugged Ridge Door Handle Recess Guards; Black (07-18 Jeep Wrangler JK 2-Door)
Read all instructions thouroughly before installation
NOTICE: For proper installation, mounting surface of item should be between 4-38° C (40-100° F) prior to application
NOTICE: This step must be done for adhesive tape to properly mount. Failure to clean could result in poor attachment of item.
1. Clean surface with isopropyl alcohol (rubbing alcohol). Avoid cleaning areas that tape will not contact.
2. Test fit item to the vehicle before removing plastic liner from mounting tape. This will aid in aligning the item before adhesion.
3. Remove only enough plastic liner to be easily gripped when item is installed.
NOTICE: The plastic liner of the shorter tape sections may need to be fully removed before installing.
4. Install item in proper mounting position while keeping partially removed liner ends accessible.
5. Firmly hold item in proper mounting position while pulling the exposed plastic liner to completely remove. Maintain pressure on installed item for 30 seconds to ensure proper contact. Full adhesion occurs within 24 hours of application.
