RPM Steering Rear 14-Inch Coil-Over Towers without Bump Cans (07-18 Jeep Wrangler JK)Find parts that fit my vehicle

2007-2018 Rear 14'' Coilover Towers JK/JKU Our RPM Steering towers are designed with proper specifications to allow a 14" coilover full range of motion on a JK/JKU. In addition, we run an 8.5" wide base so that the coilover will not rub on the tower when moving front to rear. These 1/4" steel towers are pre-welded and ready for installation. Included with the price is a set of 1/4'' steel weld on lower coilover axle tab mounts. All required gussets/ supports included with kit. When set with our recommended shaft show of 4.5'' the vehicle should net approximately 4.5''of overall lift. Pair with our 12'' Front coilover tower setup for a perfectly dialed in setup with no guess work. PLEASE NOTE: It comes with pre-welded top cap and shock tabs. Ready to weld to the frame. Sold as a pair. Shock tabs are 1/2'' bolt holes. 1.50'' tab spacing on Coilovers Towers. Pair of coilover axle tab mounts included. Crossmember gussets included. Frame to Tower gussets included. NOTE!!! This setup deletes the track bar mount. Currently designed to work with Triangulated rear suspension only. You will need to make a custom track back mount rearward of the shock tower and a custom bent track bar if you wish to maintain a track bar for a non triangulated setup. This option will be available in the near future. NOTE!!! 69'' wide axles minimum. Will not work with factory axles. NOTE!!! Cutting and welding required. recommended professional install.

Fitment:

• 2007 Jeep Wrangler
• 2008 Jeep Wrangler
• 2009 Jeep Wrangler
• 2010 Jeep Wrangler
• 2011 Jeep Wrangler
• 2012 Jeep Wrangler
• 2013 Jeep Wrangler
• 2014 Jeep Wrangler
• 2015 Jeep Wrangler
• 2016 Jeep Wrangler
• 2017 Jeep Wrangler
• 2018 Jeep Wrangler

CA Residents: WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov