How to Install Rough Country 1.5 In. Wheel Spacers on your 07-18 Jeep Wrangler JK; 2018 Jeep Wrangler JL

Please read instructions before beginning installation. Also please review tools needed list and make sure you have needed tools.

Kit Contents:
2-1 1/2” Wheel Spacers

1. Chock the tires and jack up the vehicle.

2. Remove the lug nuts and remove the tire and wheel.

3. Remove the rotor retainer star washers is so equipped using a flat head screwdriver. Removing these will allow the wheel spacer to sit flat on the rotor surface. These must be removed

4. Install the wheel spacers as shown with the supplied lug nuts. See Photo 1. Tighten to manufacturer specifications using a 19mm wrench.

5. Reinstall the tires/wheels. See Photo 2. Tighten the lug nuts holding the wheels and tires to factory specifications. Important note: Please make sure the lug nuts are tightened against the wheel surface. Some enclosed lug nuts are shorter and can create the illusion that the wheel is tight on the spacers when in fact the wheel stud is bottomed out inside the lug nut. If this occurs a longer lug nut must be purchased.

1. Re torque all fasteners after 500 miles. Visually inspect components and re torque fasteners during routine vehicle service.