FREE 1 to 3-Day Delivery on Orders $119+ Details
How to Install Rigid Industries D-Series LED Cube Lights - Flood Beam - Pair on your Jeep Wrangler
1. Connect the wiring harness by running the negative wire to the negative battery terminal (Figure A).
Figure A
2. Connect the wiring harness by running the positive wire to the positive battery terminal (Figure B).
Figure B
3. Run the wiring harness to the switch location and connect the black wire to the top terminal of the supplied Rigid switch (Figure C).
Figure C
4. Connect the red and black wire to the middle switch terminal (Figure D).
Figure D
5. Connect the red wire to the bottom switch terminal (Figure E).
Figure E
If using a normal light mount:
6. Place a supplied nut inside the mount bolt location (Figure F).
Figure F
7. Thread the bolt into the nut with the adjustable mounting piece in place (Figure G).
Figure G
8. Repeat Steps 6 and 7 on the other side.
9. Tighten the bolts down (Figure H).
Figure H
10. Utilize the bolt to connect to a traditional lighting mount (Figure I).
Figure I
11. Repeat Steps 6-10 on the other light.
If using a light side-mount:
12. Run the wiring harness connectors to the light mounting location (Figure J).
Figure J
13. Connect the light to the light mount (Figure K).
Figure K
14. Repeat Steps 12 and 13 on the other light.
Before
After
Installation Instructions Written by ExtremeTerrain Customer J. Sandlin 08/05/2018
