How to Install Rigid Industries D-Series LED Cube Lights - 60 Deg. Diffused - Fog Beam - Pair on your Jeep Wrangler

1. Carefully open the package using a box cutter or knife (Figure A) and ensure the hardware is included and undamaged.

2. Remove the wiring harness from the box (Figure B).

3. Run the positive (red ( )) wire to the positive ( ) battery terminal (Figure C).

4. Run the negative (black (-)) wire to the negative (-) terminal (Figure D).

5. Run the other end of the wiring harness to the light mounting location and the switch wiring to the switch mounting location.

6. Place the LED mounting bracket inside the underside of the LED (Figure E)

7. Place two locknuts (supplied) inside the mounting bracket and thread a bolt (supplied) into each side (Figure F).

8. Using an Allen wrench, tighten each bolt (Figure G).

9. Slide a mounting bolt and washer (supplied) into the LED mounting bracket hole (Figure H).

10. Place the LED on the light mount and tighten the supplied nut using a 13mm wrench (Figure I). 

11. Plug the LED wiring into the wiring harness connector (Figure J).

12. Repeat Steps 6-11 on the other LED.

Installation Instructions Written by ExtremeTerrain Customer J. Sandlin 06/10/2018.