Guaranteed 12/24 Delivery Still Available see item page for details! available on most items - Details
How to Install RedRock 4x4 Dual Outlet Axle-Back Exhaust w/ Polished Tips (07-18 Jeep Wrangler JK) on your Jeep Wrangler
Installation Time
60 minutes
Tools Required
- Socket Wrench with Deep Well 9/16 and 5/8 Sockets
- Lubricant (PB Blaster, WD-40 or other lubricant)
- Large Tongue-and-Grove Pliers or Exhaust/Muffler Hanger Pliers
- Hammer
- Optional: Breaker Bar
Shop Parts in this Guide
Important Note: Let the factory muffler cool down to prevent yourself from getting burned if you’ve been driving. Spend money on Jeep® parts, not ER visits.
Before Install
1. Locate the bolt that is holding the factory muffler to the exhaust pipe.
2. Break free the nut that is holding the factory band clap to the exhaust pipe using a socket wrench and 9/16 deep well socket. If the nut is extremely rusted, you may need to use a breaker bar to assist with breaking the nut free. Us a hammer to break the bolt free from the factory clamp.
3. Spray a lubricant on both driver side factory hangers and work the lubrication into the factory rubber hanger. Work the bottom metal hanger attached to the muffler through the rubber hanger using a Large Tongue-and-Grove Pliers or Exhaust/Muffler Hanger Pliers.
4. Spray a lubricant on both passenger side factory hangers and work the lubrication into the factory rubber hanger. Start to work the top hanger attached to the Jeep® through the rubber hanger using a Large Tongue-and-Grove Pliers or Exhaust/Muffler Hanger Pliers. There is more room to work with the top hanger than the bottom one.
5. Twist and pull the factory muffler until it slides off the exhaust pipe once it’s free from hangers on both sides.
6. Remove the passenger side factory hanger from the factory muffler.
7. Place a 2.5” band clamp, with the nut facing down, on the exhaust pipe of the RedRock 4x4 Exhaust that will attach to the factory exhaust pipe.
8. Twist the RedRock 4x4 Exhaust until it slides onto the factory exhaust pipe. Do not tighten the nut yet.
9. Slide the factory rubber hanger that is attached to the RedRock 4x4 Exhaust onto the passenger side metal hanger that is attached to the Jeep®. Make sure it slides all the way onto the metal hanger.
11. Tighten the nut for the 2.5” band clamp with a socket wrench and 5/8 deep well socket.
12. Slide a 2.5” band clamp on each end of the SS tips as shown below.
13. Slide one SS Tip onto the driver side of the RedRock 4x4 Exhaust outlet. Align the tip to your personal preference and tighten the nut for the 2.5” band clamp with a socket wrench and 5/8 deep well socket.
14. Repeat step 13 on the passenger side, and double check the alignment of both SS Tips.
After Install
Installation Instructions Written by ExtremeTerrain Customer Brian Voelzke 09/22/2018
