How to Install Oracle 3 in. Square Halo for Cube/Square Lights - ColorSHIFT (87-18 Wrangler YJ, TJ, JK &JL) on your Jeep Wrangler

Note: This product requires the Oracle colorSHIFT Controller (sold separately) in order to be installed properly.

1. Carefully open the package using a box cutter or knife (Figure A) and ensure the hardware is included and undamaged.

2. Take out the adhesive promoter (supplied) (Figure B).

3. Wipe the adhesive promoter along the outer frame of the 3 in. LED light being used (Figure C).

4. Remove the 3M adhesive backing (Figure D).

5. Place onto 3 in. square LED light (not included) (Figure E). 

6. Push down to ensure adhesive is fully in place (Figure F).

7. Run the wiring to the Oracle colorSHIFT Controller (sold separately).

Installation Instructions Written by ExtremeTerrain Customer J. Sandlin 05/24/2018.