Guaranteed 12/24 Delivery Still Available see item page for details! available on most items - Details
How to Install Omix-ADA Fender Flares (07-18 Wrangler JK) on your Jeep Wrangler
Installation Time
60 minutes
Tools Required
- Box Cutter/Knife
- 10mm Socket
- Socket Wrench
- Fender Flare Hardware Kit (not included)
Shop Parts in this Guide
1. Begin by removing the current fender flare from the vehicle using a 10mm socket wrench (Figure A).
Figure A
2. Once all bolts have been removed, pull the current fender flare away from the vehicle (Figure B).
Figure B
3. Remove the Omix-ADA fender flare from the box and set them upside down on a soft surface. Locate the notched openings (Figure C).
Figure C
4. Using pop-ins from a fender flare hardware kit (not included), slide pop-ins over the openings along the inside of the fender flares (Figure D).
Figure D
5. Once the pop-ins are slid into place, press down to secure each clip flat with the inside of the fender flare (Figure E).
Figure E
6. Line up the pop-ins with the fender flare holes on the vehicle and press them in (Figure F).
Figure F
7. Take the factory turn signal and move it into the hole of the fender flare (Figure G).
Figure G
Before
After
Installation Instructions Written by ExtremeTerrain Customer J. Sandlin 06/28/2018
