FREE 1 to 3-Day Delivery on Orders $119+ Details

Talk to a Wrangler Sales Tech
1-877-870-8556
M-F 8:30A-11P, Sat-Sun 8:30A-9P
Logo Image
Black Friday is Here! Shop Early Deals >
Get $80 Off Redeem Now >

How to Install an Omix-ADA Black Shifter Bezel on your 2007-2010 Jeep Wrangler JK

Installation Time

5 minutes

View PDF Guide
Extreme Terrain
Shop Parts in this Guide

Contents: Manual Shifter Bezel (1)


PLEASE READ AND UNDERSTAND ALL INSTRUCTIONS BEFORE YOU BEGIN

Step 1

Remove the shifter knob. Pull it off by firmly pulling it back and forth until the shifter knob slides off.


Step 2

Remove the existing bezel with a flat tool (e.g. Screwdriver). Pry up the rear side of the bezel, releasing the two attached clips.


Step 3

With a screwdriver, separate the lower ring from the boot joint. 


Step 4

Re-assemble parts using your Rugged Ridge bezel, joint boot and lower ring. Fasten parts together using the 8mm bolts and nuts provided.


Step 5

Re-install new assembly by sliding in the lower ring into your console then push down the assembly until it snaps firmly into place. Re-install shift knob.


For Technical Assistance Contact:

Omix-Ada Tech Support
Phone: 1-800-449-6649
Email: [email protected]
Web: www.Omix-Ada.com

​Copyright Omix-Ada 2011

Community Support

Word On The Trail

I found exactly what I was looking for at great prices with free shipping. Helpful videos and reviews as well.

mcguyverdad
Previous Slide Next Slide