Mopar Ignition Cables (07-11 Jeep Wrangler JK)Find parts that fit my vehicle

Standard Replacement Ignition Cables. Replace worn ignition cables and help your Jeep’s engine run properly once again using these Jeep Wrangler ignition cables. These cables are made to fit over 6-cylinder Jeep Wrangler JK models with precision. These cost-effective wires are simple to install, and they use the standard straight boot style that OEM wires have.

OEM Straight Boot Wires. Each of these ignition cables features a straight boot design with a straight coil connector on one end and a rubber boot to go over the spark plug on the other side. These wires are designed to remain in position as the engine vibrates.

Plastic and Rubber Exterior. These wires are designed with a solid core and a mix of plastic and rubber on the exterior. They feature rubber boots and plastic connectors going to the ignition coils.

Installs Fast. These parts install quickly and require little work to put on. An expert can put the ignition cables on in just 40-60 minutes. It’s recommended to have experts do this work, but owners can replace the wires themselves using simple hand tools. Simply remove covers to access the wires and pull them off using pliers or wire removers before replacing the original wires.

Application. These Jeep ignition cables fit 2007-2011 Jeep Wrangler JK models with a 6-cylinder engine. The wires in this pack don’t require any modifications.

Fitment:

• 2007 Jeep Wrangler
• 2008 Jeep Wrangler
• 2009 Jeep Wrangler
• 2010 Jeep Wrangler
• 2011 Jeep Wrangler

CA Residents: WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov