Mishimoto Banjo Fitting; with Bolt M20 x 5/8 Straight; Black (Universal; Some Adaptation May Be Required)Find parts that fit my vehicle

Quality upgrade replacement

Quality upgrade from OEM needed to replace the pressure sensor and decided to upgrade the oil cooler filter housing as well as quite a few other parts since I didn’t want to do the job twice. Great part well made fit perfectly casting was flawless no issues at all came with all the parts and gaskets to do the job, the one thing I did do was to use OEM sensors that was just a personal preference.

Great Upgrade to OE

Much better than the OE part. Took the better part of a full day doing it myself. Wasn't in a rush but I had a damaged o-ring on a fuel injector that cost me some time. It was hard finding a replacement o-ring but I found one. So far all is well. No more oil coating under my Jeep.

Awesome so far...

I needed to replace my cooler( It's a Jeep! Duh!!!) I had put in a dorman one previously but the oil sensor went out and I replaced it and messed up the seals. I replaced the seals and it still leaked, so I tried the Mishimoto. (Bonus, It comes with the sensors preinstalled!!) Was driving it locally for a week or so, and then had to make an emergency trip across country. Have put over 8000 miles on it and still no leak... So yes I am impressed with it!

Buy This One!

I am so impressed with this oil cooler. First off, everything is already put together - gaskets, filter, oil cooler and sensors. I checked the torque and they were all accurate. There was no slag or rough edges like is sometimes found on some other models. This thing was plug and play - no leaks at all after install.

Best Upgrade

When wheeling my Rubicon with friends their noisy fans come on mine is stays off.

Great Quality

I installed this oil cooler and as soon as I removed it from the box I could tell the quality is there. This is a must for all of these engines to avoid problems later.

Seems better than the doorman

It was nice to not have to change the sensors. Worth the extra few dollars.

Worked Great

My jeep was running hot and not getting enough air due to the bumper and winch combo. Installed this and it made a huge difference and now it runs much cooler.

Outstanding

When I finally fell victim to the infamous plastic Chrysler oil cooler failing I knew an all aluminum one was a more permanent fix. There are generally two options on the market for this solution. I went with Mishimoto as I have used them heavily building race cars in the past. I am glad that I did as the build qual is super, the packaging is well done, it comes with the cooler pre-installed and the sensors pre-installed. I did NOT have to swap any sensors off the old one on my 2015 Sahara JKU. As I’ve grown to expect, Mishimoto goes above and beyond here. Installation is about what you would find on any YouTube video covering it. Be careful with the plastic connectors from the injectors down to the oil cooler as the years of heat cycles make them brittle.

Wiring connectors

Product is built as expected and the fitment was good. The problem I had was one of the supplied oil sensors did not have the correct wiring connector for plugging into my 17 Rubicon. I had to use the one from the old unit I pulled out.