How to Install J Tops USA Soft Top Boot - Black (07-17 Wrangler JK 2 Door) on your Jeep Wrangler

1. Fold back your soft top according to the manufacturer's instructions. Folding it by pulling fabric toward you and layering will help reduce the size and prevent the top from getting pinched in the frame. 

2. Open the tailgate door and loosely slide on the soft top boot over each end. Stretch it over the frame and extend it full length left to right. 

3. Starting with the center strap, tuck and roll the fabric portion of your soft top inside the soft top boot. Pull inner flap out and loosely buckle. Continue to tuck and roll the remaining fabric on both the right and left sides and loosely buckle. 

4. Once all three buckleE have been loosely attached, start tightening the middle strap.As you tighten the strap, tuck the bottom edge of the boot underneath the top flap.This will allow water to roll off the top of the boot rather than collecting inside the boot if you should happen to get caught in the rain. 

Your new JeepTopsUSA soft top boot is now fully installed and ready to go! 

Tip: Once your boot is installed, you can stand your top on the wheel wells to make loading and unloading the cargo area easier. Make sure you lay the top down before driving though!