Differential Bearing Cap Bolt (92-01 Jeep Cherokee XJ)Find parts that fit my vehicle

LSD swap

This is a great part and very affordable, only took about 45 minutes to install and I can already notice the difference.

Dana 35 Yoke

Sent the wrong yoke. Great customer service. Fixed the issue quickly.

No problems

Perfect fit, have bought plenty of times and never any problems, fully recommend.

Great kit, no RTV needed, if you can get the pan off.

So this is a great product, I see some people like to put a RTV on the corners to hold the gasket in place while putting the screws through, not really necessary, the main issue is getting your transmission pan off and dealing with the dipstick tube, once you get the pan off the filter comes off very easily, though it is messy because more fluid dumps out, and putting the gasket on is no work at all, so I would say this could technically take 20 minutes to install if everything went perfectly, it took me two days, besides that, again great product.

Dana 44 Diff carrier bearing

This was a perfect fit, the box it was shipped in needed to be stronger. I thought the carrier or bearings were damaged if you would have seen the box, but luckily there was no damage. Hopefully this will help them with stronger packaging.

dana 44 carrier

really nice carrier very sturdy excellent product to a long time to install came with everything to install

Rear axle pinion yoke

Perfect replacement easy to install. Fixed my tj in no time

Good fit and great price

Perches fit perfectly with no gaps to fill like most options out there. Great OEM look and fit at an even better price.

Spider gears

It is a good quality part. Easy to install and fit as expected. Quieted down the rear axle hum and the rear is nice and tight again.

Clutch master/slave cylinder

It’s as simple as removing the cotter pin on the clutch and removing the slave from the bell housing and then remove the master cylinder from the fire wall (passenger side) Before full installation you will need to bench bleed the system , put the master above the slave and then slowly pump the air out of the line